8 Settings via the MICT
Rev. 08/2018
51
8.8.2
Upload, Download
Click the symbol to upload the current configuration from the VariStep3 stepper
motor driver to the MICT. If applicable, the MICT first establishes a connection
to the stepper motor driver connected.
Click the symbol to download the configuration set in the MICT to the VariStep3
stepper motor driver. This function can only be executed when the stepper
motor driver is in manual mode. This action overwrites the existing
configuration on the device. If applicable, the MICT first establishes a
connection to the stepper motor driver connected.
Existing configuration is cleared!
If you download a configuration to a VariStep3 stepper motor driver, the
previously used configuration is deleted and the new settings are
immediately implemented.
8.8.3
Compatibility Information
If you upload a configuration from the VariStep3 stepper motor driver to the MICT that does not
correspond to the status of your MICT, or if you open this type of configuration in the MICT, the
following situations may occur:
–
No values are present in the configuration for certain MICT functions. The MICT assumes the
standard values for these functions.
–
The configuration contains function values that are not support by the MICT.
The following situations can occur if you download a configuration from the MICT to a VariStep3
stepper motor driver whose firmware does not correspond to the status of your MICT:
–
No values are present in the configuration for certain firmware functions. The firmware
continues to use the preset values for these functions.
–
The configuration contains function values that are not support by the firmware.
If you download a configuration to the stepper motor driver and are notified of functions that are
not supported by the MICT, you should check the stepper motor driver settings. Re-upload the
configuration from the stepper motor driver to the MICT. You can then see which settings are not
transmitted to the MICT.
Summary of Contents for VariStep3
Page 1: ...VariStep3 Stepper Motor Driver Operating Manual P N 01 50 020 EN Rev 08 2018...
Page 16: ...4 Product Description 16 Rev 08 2018...
Page 91: ...Rev 08 2018 91...
Page 92: ......
