24
Rev. 08/2018
5.1
Installation Instructions
Unpack the stepper motor driver without damaging it and ensure that the operating manual is
always within reach of the device and easily accessible. Installation locations where strong
vibrations or ambient temperatures of below -20 °C (-4 °F) or above +60 °C (+140 °F) are present
are not permissible and result in the warranty being voided.
Risk of destruction!
The device must not be installed directly on or at the engine, as vibration
and heat may cause damage to electronic components.
Risk of destruction!
Make sure that the device is not covered and ensure sufficient circulation of
air.
Risk of destruction due to electrostatic discharge!
The VariStep3 stepper motor driver may only be installed by specialized
personnel who has been trained in handling ESD sensitive components and
with due regard to relevant ESD standards. It must be installed into a
control cabinet, and it must comply with the ESD standard DIN EN 61340-5-
1; VDE 0300-5-1:2008-07.
Damage caused by electrostatic discharge is not covered by warranty.
Scope of Supply
The supply scope of the VariStep3 stepper motor driver consists of the following components:
–
VariStep3 stepper motor driver
–
Storage device (USB flash drive or CD-ROM) including configuration software MICT
–
USB cable
–
Operating manual
Installation of the VariStep3 stepper motor driver
1.
Install the VariStep3 stepper motor driver on a horizontal DIN rail in the control cabinet.
5 Installation Instructions
Summary of Contents for VariStep3
Page 1: ...VariStep3 Stepper Motor Driver Operating Manual P N 01 50 020 EN Rev 08 2018...
Page 16: ...4 Product Description 16 Rev 08 2018...
Page 91: ...Rev 08 2018 91...
Page 92: ......
