Getting Started
21
ENGLISH
2.11
Using the Test Light
IMPORTANT
If your dog does not appear to feel the lowest level of static correction, check for
proper collar fit and that there is good skin contact where the Collar Contacts
touch the neck area of your dog, before increasing to higher levels.
You can use the Test Light that is supplied with your Wireless Fence Pet Training
System to test if the Wireless Fence Unit or the Remote Control Unit is sending
static correction to the Pet Collar Unit.
1.
Press and hold the
POWER KEY
on the Pet Collar Unit to power it on.
The unit vibrates once and the Power LED lights up in green for 3 seconds.
2.
Fit the Test Light Contacts over the Collar Contacts on the Pet Collar Unit.
3.
To test if the Remote Control Unit is sending static correction to the Pet
Collar Unit, press and hold the
STATIC CORRECTION KEY
on the
Remote Control Unit.
The Test Light will flash. The higher the level of static correction, the
brighter the Test Light flashes.
4.
To test if the Wireless Fence Unit is sending static correction to the Pet
Collar Unit, hold the Pet Collar Unit with the Test Light Contacts at your
dog’s neck level and walk towards the boundary zone.
The Test Light will flash. The higher the level of static correction, the
brighter the Test Light flashes.
NOTE
Make sure that the Wireless Fence Unit is powered on.
If the Test Light does not flash, charge the Pet Collar Unit and re-test.
If the Test Light still does not flash, contact Customer Service at
1- 888-331-3383.
Collar Contacts
Test light
contacts
Test light
contacts