Motorola Timeport P8190, Service Manual

Page: 60 / 149

Motorola Confidential Proprietary
TDMA Timeport™ P8190 Test Procedures
48
Set up for TDMA call
CALL CONTROL
Display
Active
Register
Page
Access
Connect
Cntrl Order
MS Id
Active
Register
Page
Handoff
Release
Send SMS
Phone Num
1111111111
System Type
DCCH
Cntrl Chan
42
Dig / Analog
US PCS
Amplitude
-50.0
SID
231
To Screen
CALL CNTL
CALL CNFG
CALL CNFG 2
ANLG MEAS
SPEC ANL
AUTHEN
DIG MEAS
More
Data / Meas
dBm
Traffic Chan Assisgnment
Type : -
Band : -
Chan : -
Slot :
Pwr Lvl : -
DVCC : -
Voc : -
DTC
US PCS
1
1
4
1
Phone : 111-111-1111
ESN (dec) : 156-4460397
ESN (hex) : 9C440F6D
SCM : Class IV, Continuous, 25 MHz
Protocol Version : IS - 136
Model (hex) : 4 SW (hex) : 1 FW (hex) : 4
ACELP
Figure 35. Call Control Screen
Select CALL CNTL from the To Screen
• Select System type: DCCH
• Zero the RF Power meter in the: Call
Config Screen
• Set Amplitude to: -50 dBm
• Set SID: Your phone’s System ID
• Select: Active
• Traffic Channel Assignment Type:
• Choose DTC to set up a Digital Traf
fic channel
• Type: DTC
• Chan: 1
• Slot: 1
• Pwr Lvl: 4
• DVCC: 1
Call Process
The following 4 steps need to be performed
prior to beginning registration test:
1. Enter Test Mode using FNC 0, 0, *, *,
T, E, S, T, M, O, D, E, STO.
2. Perform a 51# command in Test Mode
to clear the Historic List. Turn off the tele-
phone.
3. Connect the RF connector to the radio
and power on.
Registration
1. Put the Test Set in Active state by se-
lecting Active from the list on the left side
of the screen.
2. Select Data from the Data/Meas
field. This is the default mode.
3. Select Register from the list to regis-
ter phone.
4. If the registration message has been
received, the Test Set will display registra-
tion data in the upper half of the screen as
shown in the sample screen above.
Page
1 Select page from the list on the left
side of the screen.
2 If the mobile responds, you will see the
Access annunciator light briefly.
3 Answer the call by raising the flip or
press SEND on the mobile to start the con-
versation.
4 The Connect annunciator lights. This
is the Connect state. Data to be displayed is
shown above.
Origination
1 Dial the desired phone number on the
mobile station and press SEND.
2 The Access annunciator will light
while the Test Set signals the mobile on the
assigned voice channel.
3 The connect annunciator will light if
the mobile properly signals the Test Set.
Set up for TDMA call