46
Specific
— the MTM800 will use only the gateway with the
specified Gateway address for that talkgroup.
Upon selecting “Specific”, you will see one of the following
displays:
• The selected gateway address (e.g.:
1022), pre-programmed by your Serv-
ice Provider or previously entered by
yourself via the keypad. Press
Ok
to
use the current address, or enter a new address via the
keypad, and press
Ok
. The gateway and repeater icons
will blink upon selecting the gateway.
• “None”, indicating that no gateway
was selected for that talkgroup. Enter
an address via the keypad, and press
Ok
. The Gateway and Repeater icons
will blink upon selecting the gateway.
When the MTM800 detects the appropriate
gateway and/or the Repeater, the Gateway
and/or Repeater icons will turn solid,
respectively.
Making a DMO Group Call (
MS to MS)
1.
Press
until the Group Mode ap-
pears on your display.
2.
Press
6
2 2
(see also page 92). To
change range and talkgroup, see steps 3
and 4 of “Making a Group Call” on
page 35
3.
If this is the desired talkgroup and range,
press the
PTT
button. Wait for the “Talk
permit” tone (if configured) and then
speak into the microphone. Release the
PTT
button to listen.
GW No: 1022
Avail. Rep.
None
Selected GW:
Ok
Back
DMO Range1
DMO TG1
Optns
Status
Optns
Talkgroup 1
Range 10
Mode
2 DirectMode
Back
Ok
1 Trunk Mode
Menu
DMO Range1
DMO TG1
Optns
6815321H01_KOR.book Page 46 Thursday, November 13, 2008 8:06 AM
