Motorola T201I Series, Manual

Page: 8 / 44

T200I EN IN.2 UG .indd 8 15/05/2019 09:13
4. When the handset is fully charged, will appear steady on the display.
Plug the other end of the telephone line cord (make sure that one end is
already plugged into the base) into the telephone wall socket.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process
for all the handsets and chargers.
1. Plug the power adaptor into the socket marked on the rear of the
charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the
2 x AAA Ni-MH rechargeable batteries supplied. Please note the ’+’ and
’-’ markings inside the battery compartment and insert in the correct
direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the
charger to charge for at least 16 hours continuously.
5. When the handset is fully charged, will appear steady on the display.
The display will show
HANDSET
and handset number (e.g. 2) to indicate
that it is registered to the base.
Important
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA
Ni-MH rechargeable batteries) supplied with your T2I.
8 Getting started