32
6. Disconnect the front cover display flex from the connector on the
chassis.
NOTE:
A special locking connector secures the flex to
the chassis (see Figure 7).
a. Use the flex connector opening tool, large curved end
(Motorola part no. 6680334E08), or like instrument to help
raise the sliding portion of the connector approximately 1/8
of an inch from its seated position. A slight prying action will
achieve the best results for unlocking the connector.
b. Remove the flex from the chassis connector.
7. Remove the contoured O-ring/antenna bushing seal from the
chassis.
8. Disconnect the controls flex from the connector on the controller
board by following the procedure in step 6a and 6b.
MAEPF-27016-O
Front Cover/
Display Flex
Front Cover
Assembly
Chassis
Assembly
TECHNICAL PUBLICATIONS DEPT.
MAEPF-22572-O
Front Cover/
Display Flex
Front Cover
Assembly
Chassis
Assembly
Unit with
early Front Shield
Unit with
latest Front Shield
Figure 6 Rotating the Front Cover
Top Corner
Pry Here
Top Corner
Pry Here
Flex Locked
in Connector
Flex Released
From Connector
1/8”
Figure 7 Disconnecting the Flex
Summary of Contents for SYMBOL MT2000 Series
