Motorola Symbol LS2208, Product Reference Manual

Page: 224 / 342

13 - 6 Symbol LS2208 Product Reference Guide
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support a FN1 Substitution feature. When enabled any FN1 character
(0x1b) in an EAN128 bar code is substituted with a value. This value defaults to 7013 (Enter Key).
1.
To select a FN1 Substitution Value, scan the bar code below.
Set FN1 Substitution Value
2.
Locate the keystroke desired for FN1 Substitution in the ASCII Character Set table for the current host
interface. Enter the 4-digit ASCII Value by scanning each digit in the
Appendix D, Numeric Bar Codes .
3.
To correct an error or change the selection, scan CANCEL.
To enable FN1 Substitution for Wedge, scan the Enable Keyboard Wedge FN1 Substitution bar code on page
5-13 .
To enable FN1 Substitution for USB HID Keyboard, scan the Enable USB Keyboard FN1 Substitution bar code on
page 7-12 .
Transmit “No Read” Message
Scan a bar code below to select whether or not a No Read message transmits. Enable this to transmit the
characters NR when a bar code is not decoded. Disable this to transmit nothing if a symbol does not decode.
Enable No Read
*
Disable No Read
NOTE If you enable Transmit No Read , and also enable Symbol Code ID Character or AIM Code ID Character
for Transmit Code ID Character on page 13-3 , the scanner appends the code ID for Code 39 to the NR
message.