Motorola Symbol DS6607, Product Reference Manual

Page: 44 / 380

Symbol DS6607 Product Reference Guide 4-4
User Preferences Parameter Defaults
Table 4-1 lists defaults for user preferences parameters. There are two ways to change the default values:
• Scan the appropriate bar codes in this guide. These new values replace the standard default values in memory. To recall the
default parameter values, scan the
*Set All Defaults bar code on page 4-5 .
• Download data through the device’s serial port using SSI. Hexadecimal parameter numbers are shown in this chapter below
the parameter title, and options are shown in parenthesis beneath the accompanying bar codes. See the
Simple Serial
Interface (SSI) Programmer’s Guide for detailed instructions for changing parameters using this method.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1. User Preferences Default Table
Parameter
Parameter
Number Default
Page
Number
User Preferences
Set Default Parameter All Defaults 4-5
Parameter Scanning ECh Enable 4-5
Beeper Tone 91h Medium 4-6
Beeper Volume 8Ch High 4-7
Power Mode 80h Continuous On 4-7
Time Delay to Low Power Mode 92h 1 Minute 4-8
Trigger Mode 8Ah Auto Aim 4-10
Picklist Mode F0h 92h Disabled Always 4-11
Decode Session Timeout 88h 9.9 Sec 4-11
Timeout Between Decodes, Same Symbol 89h 0.6 Sec 4-12
Beep After Good Decode 38h Enable 4-12
Note