The SB4100 contains all necessary software.
You don't need to configure the SB4100 but
you must configure your computer for TCP/IP
(software protocol developed for communica-
tion between computers) and check for an
IP address. Your service provider may provide
additional instructions for setting up your
computer.
The following basic instructions are for
Windows 95 or Windows 98. If you are using
a different operating system, refer to that
user guide.
1
On the Windows Desktop, click Start.
2
Select Settings and then Control Panel
from the pop-up menus.
3
Double-click the Network icon on the
Control Panel window.
4
Select the Configuration tab on the
Network window for Windows 95
or Windows 98.
5
Check to see if TCP/IP has been
installed for the device being used
(Ethernet card or USB). If TCP/IP
appears in the list of network
components, it is installed and
you can proceed to step 10. If it
doesn't appear on the list, continue
with step 6.
Introduction Before You Begin Installation Operation
Basic Configuration
Troubleshooting
Configuring for TCP/IP
11
SSUURRFFbbooaarrdd
R
TM