Motorola MT712, Basic Service Manual

Page: 37 / 78

TEST SETUP & TESTING MTM700 Mobile Terminal / Basic Service Manual 5 - 5
Configuration of the IFR 2968 System Setup
The setup depends on the firmware version of the IFR 2968, the firmware version of the
radio and the customer programming of the radio.
>>The following table should be taken only as an example of how to proceed for setup.<<
Perform the following steps to configure the IFR 2968 System Setup with the radio set-
tings.
Note: Terms for 380-430 MHz radio in brackets [ ]:
1. Turn ON the IFR.
2. Press the “Systems” Mode Key (wait until the digital system is initialised).
3. Press the “Tetra Mobile” soft key.
4. Press the “Setup” soft key and enter the System Parameters Screen.
5. Press the “Channel Plan” or “System Type” soft key.
6. Press the “More” soft key if “User Defined” [“Tetra 410 MS”] cannot be seen.
7. Press the “User Defined” [“Tetra 410MS”] soft key.
Note: Press the “More” soft key, if any of the following keys is not displayed.
8. For 380-430MHz continue with step 9,
For 806-870MHz only, perform the following steps to setup the system parameters.
a. Press the “User Defined” soft key.
b. Press the “Frequency Band” soft key and press the “8 (800MHz)” soft key.
c. Press the “Offset” soft key and press the “3 (12.5kHz)” soft key.
d. Press the “Duplex Spacing” soft key and press the “1 (45MHz)” soft key.
e. Press the “Reverse Operation” soft key and press the “0 (Normal)” soft key.
f. Press the “Channel Block 1” soft key.
g. Press the “Channel Block” soft key and press the “Include” soft key.
h. Press the “Lowest Channel” soft key and enter “2040”
using the data keys followed by the “Lowest Channel” soft key.
i. Press the “Highest Channel” soft key and enter “2800”
using the data keys followed by the “Highest Channel” soft key.
j. Press the “Lowest Tx Freq” soft key and enter “806.0125”
using the data keys followed by the “MHz” key
k. Press the “Duplex Offset” soft key and enter “45”
using the data keys followed by the “MHz” key
l. Press the “Channel Spacing” soft key and enter “25”
using the data keys followed by the “kHz” key
m.Press the “Return” soft key.
n. Verify that channel block 2 to 8 are excluded.
o. Press the “Return” soft key.