Motorola MT712, Basic Service Manual

Page: 29 / 78

PROGRAMMING THE RADIO MTM700 Mobile Terminal / Basic Service Manual 4 - 3
Figure 3 PROGRAMMING WITHOUT CONTROL HEAD VIA 9-PIN CONNECTOR
CodePlug Reading
1. Verify that the supply voltage for the radio is switched off.
2. Run the Customer Programming Software (CPS) on your computer.
3. Switch on the supply voltage for the radio. Verify that no display appears on the LCD
screen.
4. Click the Toolbar “Read Phone” icon. Refer to the CPS Application Window Screen in
the CPS User Guide, Publication No. 68P02956C20. The setup enters an initializa-
tion process that takes about 20 seconds. After that, a reading process starts.
A progress bar appears on the computer screen. After the reading process is finished,
the radio Codeplug screen appears.
CodePlug Programming
1. On the menu bar, click “File” “Open”.
2. Browse for the required Codeplug file and open the file.
3. The Codeplug window appears on the screen.
4. Click the Toolbar “Write Phone” icon.
Note: The Codeplug is now being written into the radio. A progress bar is displayed on
the computer screen showing the writing status.
13 1
25 14
6
e Hardware
To Computer Serial Port
To MTM700
9 Pin Connector
Standard RS232 Cable
PC
MTM700
Connect Pin 6 to Pin 14
to switch on the radio and
to enter programming mode.