Installation
Steps
Motorola, Inc.
549453-001-00-a
Page 27 of 51
Step 3
1. Align bottom hook to bracket using slight angle. Apply firm pressure to top and bottom to snap cover in place.
2. Install two #6 set screws (supplied) in the pre-drilled holes
Step 4
1. Connect the local AC power adapter to the WallPlate
2. Connect the analogue phone to the RJ11 phone jack
3. Connect an Ethernet cable (not supplied) to a laptop
The blue LED will flash slow, then fast, to indicate the unit is linking
When the LED stops flashing, the unit is linked
Step 5
After WallPlate blue LED is solid, connect with the mT2 switch using a valid IP address and HTTP or telnet
1) AC power adapter used during installation
2) Analog phone
3) Laptop used to test the connection and enable line power