Installation
Steps
Motorola, Inc.
549453-001-00-a
Page 26 of 51
I
I
n
n
-
-
R
R
o
o
o
o
m
m
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Note:
These instructions follow the
Installation 1
procedure from the previous chapter. Please consult
WallPlate Installation
for variations of the installation routine.
Tools Required:
Number 2 Philips head screwdriver
Number 2 flat blade screwdriver
Components provided with the m2a WallPlate:
1 – m2a WallPlate bracket and cover with circuit board
1 – 150mm (6”) RJ11 pigtail cable
1 – RJ11 blanking plug
2 – Number 6 oval head screws, 0.25”
Components required to purchase:
Regulated 12V power supply. Use of the wrong power supply could result in damage to your WallPlate unit. Please
order a small quantity of regulated 12V power supplies from Motorola PBN to use during installation.
If you do not have the correct regulated 12V power supply –
STOP
. Order a regulated 12V power supply from your
Motorola PBN sales representative.
Step 1
1. Loosen screws on wall plate approximately 6mm (1/4”)
2. Attach the bracket using the keyhole slots
3. Tighten screws until the bracket is firmly attached, do not over tighten
Step 2
Connect 150mm (6”) cable (supplied) between m2a circuit board and existing RJ11 jack.
