User’s Manual
M68EML08GZ16 Emulation Module - Version 4.0
MOTOROLA
M68EML08GZ16 Quick Start Guide
9
User’s Manual — M68EML08GZ16 Emulation Module
M68EML08GZ16 Quick Start Guide
Make sure that power is disconnected from your M68EML08GZ16 Emulator
Module and from your target system. Then follow these quick-start steps to
make your M68EML08GZ16 ready for use as quickly as possible.
1 - Set jumpers W4, W5 and W6
Jumper header W4 specifies the clock source for the MCU when you enable its
external clock.
•
Place the jumper between pins 3 and 4 (factory default) to specify the
debugger-controlled oscillator from the platform board or place the
jumper between pins 1 and 2 to specify 4.9152-MHz oscillator Y2, which
can be replaced with an oscillator of a different value.
Jumper header W5 specifies the MCU flash size.
•
Place the jumper in the appropriate location for the flash size of the MCU
you want to emulate. Valid emulation MCUs are MC68HC908GZ16,
MC68HC908GR16, MC68HC908GZ8, MC68HC908GR8, or
MC68HC908GR4.
Jumper header W6 specifies an HC08GZ or HC08GR family MCU.
•
Place the jumper between pins 2 and 3 (factory default) to specify an
HC08GZ family MCU or place the jumper between pins 1 and 2 to
specify an HC08GR family MCU.
2 - Install the emulation module into your development system
To use the M68EML08GZ16 in an MMDS0508 Motorola Modular
Development System (MMDS) or MMEVS0508 Motorola Modular
Evaluation System (MMEVS):
•
Remove the access panel of the MMDS station-module enclosure.
