LX2
plus / advanced and LX4 plus / advanced
B2270901
Content is subject to change without notice!
25
4.3
Charging Unit
Work carefully to avoid damaging the PCB and housing.
4.3.1
Removing/ Replacing The Top Housing
§
Insert a size No. 2 slotted screw driver vertically into the holes in front of the bottom
housing (refer to Fig. 1).
§
When it is positioned between the snap and the catch turn the screw driver by max.
1/8 turn and separate bottom and top housing with your fingers at the same time (refer
to Fig. 2).
§
Insert the screw driver vertically into the holes in the back of the bottom housing (refer
to Fig. 3).
§
Turn the screw driver by max. 1/8 turn and separate bottom and top housing with your
fingers at the same time (refer to Fig. 4).
§
Take off the cable connected to the contact pins from the printed circuit board.
§
Remove the top housing.
§
Before replacing the top housing check that the reset button is positioned correctly.
§
Replace the cable connected to the contact pins on the PCB.
§
Align the top housing with the PCB so that the reset button matches the hole in the
top housing.
§
Press the top and bottom housings together with force and let it snap into each other.
Fig. 1
Fig. 2
Fig. 4
Fig. 3
catch
snap
catch
snap