Motorola FX7400 Series, Integrator Manual

Page: 40 / 116

4 - 2 FX Series RFID Readers Integrator Guide
Managing the FX Series RFID Readers
The reader must be powered up (see System Start-up/Boot LED Sequence on page 3-5 ) and connected to an
accessible network. The power LED is green indicating the reader is ready. If the green power LED is not lit, reset
the reader. See
Reset Reader on page 4-2 .
The install/startup sequence is:
1.
Installation on page 3-2
2.
Communications Connections on page 3-6
3.
Connect to the Reader on page 4-3
4.
Administrator Console Login on page 4-8
a.
First Time / Start-Up Login on page 4-8
b.
Normal Login on page 4-11
Profiles
Use profiles for multiple reader deployments to save configuration time, as only a few APIs are needed to
completely configure a reader. See
Reader Profiles on page 4-26 .
Reset Reader
To reset the reader, press and hold the reset button for not more than 2 seconds. See Figure 2-4 on page 2-5 for
the reset button location. This resets the reader and retains the user ID and password. The reader reboots. See
System Start-up/Boot LED Sequence on page 3-5 .
NOTE
The recommended browsers are IE 6 and Mozilla 3. These browsers have been tested and validated to
work properly. Other browsers may or may not work properly.
NOTE
The screens and windows are provided for illustration purposes only and may differ from actual screens.
The applications described may not be available on (or applicable to) all devices.
Procedures are not device specific and are intended to provide a functional overview.
NOTE
Hard rebooting the reader (disconnecting power) is not recommended. A hard reboot discards all the tag
events and system log information.