Motorola FX7400 Series, Integrator Manual

Page: 27 / 116

Getting Started 2 - 5
Figure 2-4
FX Series RFID Reader Rear Panel Connections
FX Series RFID Readers Rear Panel
Port 1 Port 2 Port 3 Port 4 GPIO 24 VD
Antenna Ports (Four Ports, Reverse TNC) USB Power GPIO 10/100BaseT Ethernet
(with POE)
Reset
CAUTION
Use only parts provided with the FX Series RFID readers, or Motorola approved/recommended parts.
Substituting other cables or parts can degrade system performance, damage the reader, and/or void
the warranty.
Table 2-1
FX Series RFID Readers Rear Panel Description
Port Description
Antenna Ports
(Reverse TNC) Two port version: Connect up to two antennas.
Four port version: Connect up to four antennas.
See
Table A-1 on page A-1 for the maximum antenna gains and RF output powers for both
US/Canada and EU.
Reset To reset the reader insert a paper clip into the reset hole, press and hold the reset button for not
more than 2 seconds. This resets the reader, but retains the user ID and password.
GPIO Insert a DE15 serial cable to connect to external devices.
USB ActiveSync is enabled by default on the USB client port. Use Visual Studio to use the USB port
for development. Use a remote display tool to access the Windows CE graphical interface.
Advanced users can disable and enable ActiveSync via a registry change in Windows CE,
and can create a custom communication protocol on the USB port.
10/100BaseT
Ethernet Insert a standard RJ45 Ethernet cable to connect to an Ethernet network with or without POE
capability. Insert a cross-connect Ethernet cable to connect to a local computer.
Power DC connector connects to a Motorola approved power supply AC adapter (varies depending on
the country). Maximum power 24 VDC, 1.2 A.