Motorola DSR-4530, Operator'S Manual, Page: 55 / 92

DSR-4530 49
Operating the DSR-4530
Status2 Menu
Note: This menu is not displayed when the active signal is received from a source
other than an L-band input connector.
Press the
56
buttons until the Status2 menu appears (shown below). This screen
displays the source name, channel number, and the signal quality.
Source Field Default: Not in map
The Source field (two to eight alphanumeric characters) displays the name of the
transponder (source) to which the unit is tuned. The IRD displays Not in map when
the transponder name is not available and three dashes (---) when no information is
available.
Channel Field
The Channel field displays the selected virtual channel number (from the Channel
menu on page 34). The range is 0000 to 4095. Four dashes (----) are displayed
when no information is available.
Quality Field
The Quality field displays a number from 1 to 100 indicating the level of the signal
quality. If the signal is 50 or less, it is marginal. If it is 35 or less, take action to
increase the dish size or improve the reception by the LNB to prevent occasional
loss of output.
Note: The signal quality is also displayed as a large bar graph in the Status3
menu.
Status3 Menu
Note: This menu is not displayed when the active signal is received from a source
other than an L-band input connector.
Press the
56
buttons until the Status3 menu appears (shown below). This screen
displays the quality level of the active signal received from the L-band source and is
shown as a large bar graph that expands to fill the entire LCD screen.
E --- ---- ---
STATUS2 Source Channel Quality
Read-only
Read-only
Read-only
Read-only