Motorola CP110, User Manual

Page: 55 / 146

PROG
RAMM
IN
G
F
E
ATURES
English
53
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is
heard.
6. Place the “Source Radio” in its SUC, press and
release Side Button 1 (SB1).
7. After cloning is completed, the “Source Radio”
will sound either a “pass” tone (cloning was
successful) or a “fail” tone (cloning process has
failed). The pass tone sounds like a good key
“chirp” whereas the “fail” tone sounds similar to
a “bonk” tone. If the “Source Radio” is a radio
with a display, it will either show “Pass” or “Fail”
on the display. (A tone will be heard in no more
than 5 seconds).
8. Once you have completed the cloning process,
you should turn the radios “OFF” and “ON” to
bring them to normal user mode (exit “clone”
mode).
What to do if cloning fails
The radio will emit an audible “bonk” indicating
that the cloning process has failed. In the event
that cloning fails, try performing each of the
following before trying to start the cloning
process again.
1. Make sure that the radio batteries on both
radios are fully charged.
2. Verify the cloning cable connection on both
SUCs.
3. Make sure that the battery is engaged properly
on to the radio.
4. Make sure that there is no debris in the
charging tray or on the radio contacts.
5. Verify that the source radio is in cloning mode.
6. Make sure that the radio to be cloned is turned
ON.