Motorola CP110 UHF, User Manual

Page: 39 / 138

PROG
RAMM
IN
G
F
E
ATURES
English
37
The following is an example of the order in
which your radio will be signaling the ‘118’
CTCSS/DPL code:
Figure 3: Example of How to Program Values
• Short press the PTT button. The radio will signal
you the first digit ‘1’.
• Short press PTT button again and the radio will
show the second digit ‘1’ and,
• Finally, short press PTT again and radio will show
the third digit ‘8’.
Reading Auto-Scan Values
After reading the CTCSS/DPL codes, short
press the PTT button and the radio will take
you to Auto-Scan (refer to Stage 3 of
Figure 3:
Entering Programming Mode on page 37).
Auto-Scan only has two values:
Note: While in Auto-Scan Mode, if you short press
PTT button, the radio will return to the ‘Idle’
Programming Mode. It will then generate a
‘roll-over’ chirp and it will start blinking a
green heartbeat
If the radio signals
the value…
It means
Auto-Scan is…
0 OFF
1 ON
• Auto-Scan is set to OFF by default.