10. Fasten the camera body to the wall plate using the wall plate mounting screws.
11. Replace the locking ring to secure the conduit pipe.
Mounting the Dome Camera to an Electrical Box
Perform the following steps if the required electrical components and cables will be contained in an
electrical gang box inside the mounting surface.
1. If a flush mount is preferred, remove the wall plate gasket.
2. Mount the wall plate to the electrical box. Use the hole configuration that matches the box:
A — UK standard single gang box
B — Octagon gang box
C — 4” gang box
E — US standard single gang box
Note:
It is recommended that silicone sealant be applied around the edges of the wall plate
gasket to prevent moisture from entering the mounting surface or electrical box.
3. Pull the required cables through the cable entry hole on the wall plate.
Mounting the Dome Camera to an Electrical Box
36