Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit
•
User Guide
16
590631-001-a
Notes
:
ο
You can use either
OUT
connector on the RF splitter (included) for this installation.
ο
You may want to install a MoCA filter (included) between your gateway and RF splitter
(see Figure 12) to ensure maximum cable modem network performance.
11.
Connect a fourth coaxial cable (included) to the other
OUT
connector on the RF splitter and
the
Coax In
connector on the SBM1100 adapter (see Figure 12).
12.
Connect an Ethernet cable to the
Ethernet
port on the SBM1100 adapter and one of the
LAN Ethernet
ports on your gateway (see Figure 12).
13.
Connect one of the power adapters (included) to the
Power
port on the SBM1100 and plug it
into an electrical wall outlet (see Figure 12).
ο
The
Coax
LEDs on both MoCA adapters should turn ON within five minutes to indicate
that a secure coaxial link was established between the two adapters.
ο
If the
Coax
LED does not turn ON within five minutes, disconnect the power adapter
from both MoCA adapters and then reconnect them, if the
Coax
LEDs still fail to turn
ON, see
14.
Power ON your Smart TV, set-top box, laptop, and any other Ethernet-connected devices.
You can now configure your Smart TV and other Ethernet-enabled devices for Internet access
through their related user interfaces.
See
for more information on setting up the MoCA adapters.