Sarix Professional 4 Bullet Camera Installation Manual
C6726M | 11/22
8
Installation
Camera Package Contents
l
Pelco Sarix Professional 4 Bullet Camera
l
Junction box
l
Mounting template sticker
l
4 screws and anchors for solid walls
l
4 screws for attachment to electrical box
l
Protective rubber boot for Ethernet port
l
Teflon tape
Installation Steps
Mounting the Bullet Camera
If the cables for the camera will not be provided from inside the mounting surface, install the junction box
first. After you install the junction box, you can skip directly to step 3 of this procedure.
1. Use the mounting template to drill four mounting holes into the mounting surface.
2. Drill the cable entry hole into the mounting surface then pull the required Ethernet cable through
the cable entry hole.
3. Fasten the junction box to the mounting surface.
To prevent moisture from entering the junction box, it is recommended to apply teflon tape around
the threaded conduit pipe at the cable entry point of the junction box. Ensure the other two conduit
plugs are fully tightened.
