IndigoVision Multisensor Dome Camera
The IndigoVision Multisensor Dome camera uses the same settings as the other cameras referenced in this guide, with
the exception that these settings are multiplied by the number of heads on the camera. You can configure the settings
for each head on the camera individually.
When you see the camera's video display, you will see either three or four image panels displayed — one for each head
on the camera:
The top-left image panel is always for Head 1. The odd numbered heads are displayed on the left, and the even
numbered heads are displayed on the right.
To control the video display:
l
Click on an image panel then use the zoom and focus controls to adjust the video image.
l
Move your mouse into the image panel then click
to maximize the image panel. Click
to restore the
image panel.
Changing Settings Per Camera Head
When you adjust the video image settings, you will typically see a tab for each camera head. To change settings for a
specific camera head, select that head's tab on the settings page and make the required changes.
If no tabs are displayed, the settings apply to the camera as a whole.
The All Heads tab is only displayed on the Image and Display, Adjustments, and Motion Detection pages. The All Heads
tab on these pages allows you to change settings that apply to the whole camera and settings that can apply to
specific camera heads.
IndigoVision Multisensor Dome Camera
32
