8A
8B
V
PU
SERR.
L N
LAMP
230V
MOTORE 1
AP COM CH
MOTORE 2
AP COM CH
1
1
1
2
2
2
3
3
3
4
4
5
5
6 7 8 9 10
1
1
2
2
3 4 5 6 7 8 9 10 11
MOT.2
SERR.
+ - + V
CN1
CN2
MOT.1
LAMP
+ -
BAT
+12V-
12/20V
S.P.
+
EN
EN
06. COMPONENTS TEST
230V MOTOR
AUTOMATISM
8μF (230V) / 20μF (110V)
Capacitor
1
2
3
2
COM 1
COM 2
COM
Ground Wire
Phase 2
Phase 1
Open
Close
Motor
Power Supply 1
Power Supply 2
Fig. 23
To detect if the malfunction is on the control board or on the motor is, sometimes, necessary to perform
tests with connection directly to a 230Vac power supply.
For this, it is necessary to interpose a capacitor on the connection in order to the automatism to work
(check the type of capacitor to be used in the product manual).
The diagram below, shows how to make that connection and how to merge the different components
wires.
All tests must be performed by qualified personnel due to serious danger associated
with the misuse of electrical systems!
NOTES:
• To perform the tests, there is no need to remove the automatism from the place it is instal-
led, because in this way, it is possible to understand if the automatism can function properly
connected directly to the current.
• You should use a new capacitor during this test to ensure that the problem does not lie on it.
1 • Connect the power wires to the terminal, as shown below.
2 • Connect the automatism wires in the terminal, interposing a capacitor in the
opening and closing wires.
3 • Once these connections are completed, connect to a 230Vac power outlet, depending on the motor /
control board in test.
230V MOTOR
05. CONNECTION SCHEME
MOTOR WIRES
|
CONNECTIONS
Connections should be made as shown above, connecting the 6 motor wires to the appropriate inputs
of the central and capacitor.
NOTE
: The white motor wires are connected directly to the capacitor wires!
24V MOTOR
Yellow/Green
Black
Blue
Brown
Black
Black
Wires color
Motor 1 wires
Motor 2 wires
Ground Wire
MOTOR-AP
MOTOR-COM
MOTOR-CH
Capacitor
Capacitor
Ground Wire
MOTOR-AP
MOTOR-COM
MOTOR-CH
Capacitor
Capacitor
•
These connections correspond to an
installation with an opening to the interior
. If the au-
tomation is installed with an opening towards the
outside
of the gate, you
must swap the AP
wire with the CH wire
on the motor 1 and 2.
•
If the
motors work towards the opposite direction, swap AP with CH
.
