12
1
2
3
4
5
6
7
8
50mm
EN
FIX BOOM SUPPORTS
03. INSTALLATION
You should now set its length so that you can then place the support as shown in the image below.
The boom should exceed the position of the support arm by 50mm.
After placing the boom to the desired size, secure it with
the two self-tapping screws to the fixed part of the boom.
When the boom length is established, set the location of the boom
support to ground.
If the height of the support arm is misaligned to the height of the boom you will have to adjust the arm
height. To do this follow these steps:
Drill two holes in the installation location to secure the
support with screws and dowels.
Loosen the support arm locking pin with a hex wrench
Fit the hole in the support to the bolts already in place
and tighten with the nuts.
Raise or lower the support arm to place the support to the height necessary to support the barrier.
Place the nut´s protective caps.
Tighten the support arm lock pin with to lock
the support in the set position.
•
SET EXTENDABLE BOOM LENGTH
•
BOOM SUPPORT (FIXED) APPLICATION
•
ADJUSTING SUPPORT (FIXED) HEIGHT
4
7
5
8
1
2
3
6
