8
90º
3
3
3
4
5
1
4B
4A
5
4C
I
E
EN
03. INSTALLATION
FIXING WITH LEGS
SCREW TIGHTENING
At the end, tighten the lateral profiles to the legs. Tighten the screws and place the ø20mm caps in
the holes.
ASSEMBLY OF THE FRAME
Place all profiles of the frame on the floor, aligned in the correct position for assembly.
PROFILE FITTING
Apply the sealing silicone to the diagonal faces of the various profiles.
The two fixing structure are mounted between the legs and the rear and front profiles, and then
the side profiles are fitted through the union joints.
Clean the silicone
(see detail A).
DETAIL A
FIX THE LEGS TO THE FRAME
Tighten the legs of the awning to the
frame.
Apply the screws.
FIX THE FIXING PLATES
Position the fixing plates in the holes.
Mark the holes in the floor.
Drill the holes and place the anchor bolts
suitable for the drilled hole.
Make sure that it is as indicated in image
4B
, with the crossbar of the legs outside
and the hole towards the inside, and
finally the fitting in figure
4C
.
CLEAN EXCESS SILICONE:
Inside, leave a visible silicone line for total isolation of the union joint
between profiles.
Outside, completely wipe off excess silicone so it will not be visible.
1
2
3
4
5
I
E
Measure the diagonals to ensure approximately
90°
angle (difference of
2mm
at the maximum).
