7
90º
ø20mm
ø10mm
1
2
3
5
6
7
3
8
7B
2A
2B
7A
5
7C
I
E
EN
03. INSTALLATION
FIXING TO THE WALL AND WITH LEGS
DETAIL A
DETAIL B
FIX PROFILE ON THE WALL
Attach the installation profile to the wall.
FIX THE FIXING PLATES
Position the fixing plates in the holes.
Mark the holes in the floor.
Drill the holes and place the anchor bolt suitable for the hole created.
Make sure the legs are installed according to figure
7B
.
FIX THE LEGS TO THE FRAME
Tighten the legs of the awning to the frame. Apply the screws.
SCREW TIGHTENING
At the end, tighten the lateral profiles to the legs. Tighten the screws and
place the ø20mm caps in the holes.
MARKINGS ON APPLICATION PROFILES ON THE WALL
Mark the holes in the profile to be installed on the wall
(see detail A on page 6A)
.
PROFILE FITTING
Apply the sealing silicone to the diagonal faces of the various profiles. Mount
a fixing structure between the legs and the front profile, and then the side
profiles are fitted using union joints. Clean the silicone
(see detail B)
.
CLEAN EXCESS SILICONE:
Inside, leave a visible silicone line for total
isolation of the union joint between profiles.
Outside, completely wipe off excess silicone so it
will not be visible.
HOLES IN THE APPLICATION PROFILES
ON THE WALL
Drill the markings along the profiles with
Ø10mm
(2A).
Then widen the hole in the
inner wall to
Ø20mm
(2B), so that the screw
head can move inwards.
HOLES ON THE WALLS
Raise the profile to the fixing wall, mark and make the holes with
ø10mm
. Insert the anchor bolt.
1
2
3
4
5
6
7
8
I
E
Measure the diagonals to ensure approximately
90°
angle (difference of
2mm
at the maximum).
Where there is no screw, apply
silicone and place stickers.
F
G
F
Make a cut in the caps as shown
in figure G before placing them.
G
6A
G
