7A
7B
295mm
529mm
60mm
60mm
11
16
14
15
17
12
13
EN
EN
To ensure full operation of the automatism, pay attention the following recommendations:
• Read the entire manual at least once giving special attention to all notices marked
with ;
• Check that the gate structure is sufficiently resistant;
• The gate should be very well leveled and have a uniform movement without irregular
friction during the full course;
• The foundation to create in step 02 should be very resistant to support the mounting
screws of the plate;
• It is recommended that all locksmith works are carried out before proceeding with
installation of the automatism.
• Check if the size and weight of the gate correspond with the presented with the
technical data of the motor (p. 6B).
INSTALLATION SITE PREPARATION
INSTALLATION SITE PREPARATION
04. INSTALLATION
04. INSTALLATION
SITE INSTALLATION – CREATE FOUNDATION
NOTE:
For correct operation of the automatism, it is necessary to pay attention to the dimensions
given in the following images. Also check that the fixation plate is parallel to the gate.
01
• Make a hole in the ground to create a foundation in concrete. The dimensions
shown are these recommended to create the foundation. You must leave tubes in the
middle of the hole for the passage of cables for power and accessories, as shown in the
detail of image 11.
02
• Fill the hole with fresh concrete and
smooth the top part where you will fix the
plate.
03
• Attach the screws to the plate with
nut and counter nut as shown in picture
13.
04
• Insert the plate with screws in the concrete while it is still fresh and level it
horizontally with a level. Also align it parallel to the gate, keeping a distance of 60mm
between them, as visible in picture 16.
05
• Let the concrete dry so that the plate stays well fixed.
DETAIL 11
EN
EN
