8
9
20V ULTRA RAPIDCHARGE 1-Hour Quick Charger
(MH-03-C-B1-20V1H-1)
20V ULTRA RAPIDCHARGE 1-Hour Quick Charger
(MH-03-C-B1-20V1H-1)
Voltage
120V~60Hz
Output voltage
21.2V DC 2.4A
OPERATION
CHARGING THE BATTERY PACK
The battery pack for this tool has been shipped in a low charge condition to prevent
possible problems. Therefore, you should charge it until the green LED on the front right
hand side of the charger comes on.
First read the safety instructions then follow the charging instructions.
Plug the charger into a standard 120V~60Hz mains socket outlet, the green LED on the
front left hand side of the charger will illuminate to indicate.
Do not allow the cable to become knotted or kinked.
Place the battery pack into the charger base. (Note the battery has raised ribs which
allows it to fit into the charger only one way).
2,0 Ah -battery, charge for 60 minutes
4,0 Ah -battery, charge for 130 minutes
The red LED on the front right hand side of the charger will illuminate to indicate
charging is in progress. A green LED will illuminate when the battery is fully charged.
Unplug the charger when not in use and store it in a suitable storage cabinet.
Avoid charging your battery in freezing conditions as charging power will not be
sufficient.
When charging more than one battery pack in succession allow at least 30 minutes for
the charger to cool down before charging an additional battery.
Always remove the battery pack and store it safely when the tool is not in use.
Warning! Only charge in compatible 18V chargers. Use of other chargers may result in
fire, damage or serious personal injury.
Caution:
If at any point during the charging process none of the LEDs are lit, remove the
battery pack from the charger to avoid damaging the product. DO NOT insert another
battery.
Warning!
Do not at any time let brake fluids, gasoline, petroleum based products,
penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Note:
Batteries will not reach full charge the first time they are charged. Allow several
cycles (operation followed by recharging) for them to become fully charged.
MAINTENANCE AND REPAIRS
Service, testing and repairs should only be carried out by authorised service centres.
From time to time the ventilation slots on the motor casing should be cleaned out. If the
unit should become defective, repair should be performed by an authorized service
agent.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various types of commercial solvents and
may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
STORAGE
It is not recommended to leave it in a cold works van overnight. Ensure no metal filings
or swarf can fall into the vents during storage, as this may cause serious injury when it is
next used.
TECHNICAL SPECIFICATION
SYMBOLS
The rating plate on your tool may show symbols. These represent important information
about the product or instructions on its use.
Volts
Amperes
Hertz
Watts
Alternating current
Direct current
Class II construction
Safety Alert
Read Operator’s Manual
Wet Conditions Alert
Risk of fire
Indoor use only.
V
A
Hz
W
or a.c.
