11
Simplified vehicle circuit diagram with m-Button (optional accessory)
The circuit diagram below shows a simplified vehicle wiring loom with use of the m-button.
Therefore 6 wires do not apply, because only one cable is needed to connect handle bar controls
with m-unit.
THE M-BUTTON MUST LOCATED INSIDE A METAL HANDLEBAR TUBE.
8.8.1 Special features
START Output
The starter output consists of two connection terminals. Starters with integrated solenoid (magnetic
switch) with a current flow of maximum 30A (e.g. Valeo, Bosch, Harley Davidson), are connected
using a connection cable with 2,5mm² cross-section to one of the two outputs. Starters with a
solenoid generating currents up to 50A will require both connecting terminals using cables with
2,5mm² cross-section.
All starters with separate starter relays (e.g. Japanese models) must continue to be operated using
the original starter relay. In this case, the output „start“ is connected to the relay which switches the
actual cranking current (>100A). On some vehicles, this starter relay is switched using a second
relay for protection of start push button. This second relay will become obsolete.
IGNITION Output
This output powers the ignition system. The ignition system must be connected to this output
only.
AUX1 Output
All loads like rear light, license plate light, radio, heated grips etc. are powered by this output. In
setup menu, different configurations of this output are possible depending on the use.