BLEEDING INSTRUCTIONS
Sect. 3 - USE AND MAINTENANCE
MGS corsa user's manual - page 3-37
BLEEDING THE CLUTCH MASTER CYLINDER
•
Insert one end of a transparent plastic tubing inside the clutch master cylinder bleed valve (1) and the other end
in a container.
•
Pump the clutch lever quickly. Repeat several times, then keep the lever pulled in.
•
Slacken the bleed valve (1) by one quarter of a turn to let the fluid drain into the container; this will remove any
tension from the lever and help it travel fully home.
•
Retighten the bleed valve (1) before the lever is fully squeezed in.
•
Repeat process until the fluid draining into the container is totally clear of air bubbles.
•
Retighten the bleed valve (1) before the lever is fully squeezed in.
•
Repeat process until no more air is coming out.
•
Tighten the bleed valve (2) and remove the tubing.
BLEEDING THE CLUTCH SLAVE CYLINDER
•
Slip the rubber cap off the bleed valve (2) of the clutch slave cylinder.
•
Insert one end of a transparent plastic tubing inside the clutch slave cylinder bleed valve (2) and the other end in
a container.
•
Pump the clutch lever quickly. Repeat several times, then keep the lever pulled in.
•
Slacken the bleed valve (2) by one quarter of a turn to let the fluid drain into the container; this will remove any
tension from the lever and help it travel fully home.
•
Retighten the bleed valve (2) before the lever is fully squeezed in.
•
Repeat process until the fluid draining into the container is totally clear of air bubbles.
•
Tighten the bleed valve (2) and remove the tubing.
•
Add clutch fluid to the reservoir until bringing fluid up to correct level, see 3.1.2 (CLUTCH FLUID).
•
Refit the rubber cap.
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
