LEVELS
Sect. 3 - USE AND MAINTENANCE
MGS corsa user's manual - page 3-11
3.1.4
GEARBOX OIL
CHECKING AND TOPPING UP
•
Keep the vehicle upright with both wheels on the ground.
•
Unscrew and remove the level plug (1).
•
Correct level is just below the hole of the level plug (1).
If necessary, top up transmission oil level as follows:
•
Unscrew and remove the oil filler plug (2).
•
Top up with oil, see 2.1.3 (LUBRICANT TABLE) until level reaches the hole of the level plug (1).
WARNING
Do not put additives or other substances into the fluid.
If you use a funnel or other tool, ensure it is perfectly clean.
CHANGE
WARNING
Change oil when unit is hot, as oil will be more fluid and will drain off more easily.
CAUTION
Letting the engine idle with the vehicle at standstill is not the correct procedure to warm engine and engine
oil up to operating temperature for an oil check. Oil is best checked after taking a short ride; 15 Km (10 mi) will be
enough.
•
Place a container holding more than 400 cu cm (25 cu in) under the drain plug (3).
•
Unscrew and remove the drain plug (3).
•
Unscrew and remove the oil filler plug (2).
•
Drain the oil into the container and let the last of the oil drip out for several minutes.
•
Check the sealing washer of the drain plug (3) and replace it if worn.
•
Clean off any metal debris sticking to the drain plug (3) magnet.
•
Refit the drain plug (3) and tighten.
•
Fill fresh oil, see 2.1.3 (LUBRICANT TABLE) through the oil filler hole (2) until level reaches the hole of the level
plug (1).
WARNING
Do not put additives or other substances into the fluid.
If you use a funnel or other tool, ensure it is perfectly clean.
•
Refit and tighten the plugs (1 – 2).
www.guzzitek.org + www.guzzitech.com - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
