MOTO GUZZI Griso V1100, Workshop Manual

Page: 28 / 182

GENERAL TECHNICAL INFORMATION
2 - 9
Griso V1100
DESCRIPTION Q.ty
SCREW / NUT
TIGHTENING
TORQUE
(Nm)
Note
SWINGING ARM
Swinging arm clamp to bush fastener 2 6
X
25 10
Swinging arm to bevel gears fastener 4 M10x35 50
Linkage to bevel gears fastener 1 M10x50 50
Linkage to frame fastener 1 M10x50 50
Swinging arm shaft to swinging arm fastener 1 M12x1.25 60
Preload bush to swinging arm shaft fastener 1 M25x1.5 10
FRONT SUSPENSION
FRONT FORK
Tube stop plate to bottom yoke fastener 2 M5x16 6
Fork leg to steering head fastener 2 M8X30 20 Stainl.steel A4 cl. 80
Stainl.steel A4 cl. 80
22 First tighten top screw to 22 Nm
22 Then tighten bottom screw to 22 Nm
Fork leg to bottom yoke fastener 6 M8X30
18 Then tighten centre screw to 18 Nm
Steering tube ring nut 1 M35x1 40
Steering tube lock ring nut 1 M35x1 Man. 0 to 90 degrees
Steering head plug 1 M29x1 100 Use a torque wrench
Fork clamps blanking 2+2 M8X40 25
REAR SUSPENSION
SHOCK ABSORBER
Shock absorber to frame fastener 8.8 1 M10x80 50
CONNECTING RODS
Double connecting rod/shock absorber fastener
10.9
1 M10x47 40
Single connecting rod/double connecting rod
fastener 10.9
1 M10x95 50
Single connecting rod to frame fastener 8.8 1 M10x85 50
Double connecting rod/swinging arm fastener 10.9 1 M10x82 50
AIR BOX – BLOW BY
Expansion tank spacer to engine fastener 1 M6 10
Blow by expansion tank to spacer fastener 1 M6 10
Air box to frame fastener 2 M6x20 10
EXHAUST
Exhaust pipe to engine fastener 4 M8x1.25 25
Silencer connecting tube to frame fastener 1 M8X50 25
Silencer to footrest support fastener 2 M8X45 25
Protection to connection tube fastener 1 M6 10
Oxygen sensor fastener 1 M18x1.5 38
Clamp fastener 3 M6 10