![background image](http://html.mh-extra.com/html/motionrc/f180/f180_user-manual_1837931004.webp)
HELICOPTER PARAMETERS
Length
400 MM
Height
120MM
Weight
297g
Length of Main Propeller
410MM
Diameter of Tail Propeller
73MM
Battery Specification
11.1v 700mah 30C
Flight Time
6-10 Min
Main Brushless Motor
3606
Brushless Tail Motor
1104
WARNING AND THE GUIDE OF BATTERY USAGE
To ensure safety, please use the included standard charger
WARNING:
It is recommended to use the original power supply charger when charging,
otherwise property damage and injury will occur.
Notice:
When it is lower than 11.1V, the lithium battery may be damaged, or it may no longer
be charged. When the battery voltage is lower than 11.1V when the aircraft is flying,
the power of the aircraft drops significantly. Please immediately land and charge the
battery in time.
BATTERY CHARGING
11.1v 700mAh
-4-
1. The user should connect to the power adapter with a USB
port or connect to the USB port of computer.
2. Connect the USB cable to the power adapter, at the same
time the USB charger red light flashes.
3. The partial voltage charging head of the battery is connected
with the USB cable. At this time, the USB charger's red light
always on and charging is in progress.
4. When the USB charger red light is off, charging is completed.
Warning
1. To ensure safety, please charge under the supervision of someone.
2. Children cannot charge alone, they should charge with the assistance of an adult.
3. Please use the original standard charger of this product for charging. The charger of
unknown origin may cause a fire and explosion accident.
4. It is recommended that users prepare their own 2A current adapter, which will shorten
the charging time.
NOTICE BEFORE FLIGHT
1. Make sure the battery power is full both for TX and helicopter.
2. Before open the power of TX, please make sure the TH. Stick at the bottom and the
switch of TH.HOLD and 3D mode in back position (back cover direction).
3. Make sure the TX has successfully paired with the helicopter
;
if not pair them again.
4. Please open TX first, then connect the battery with the RX board on helicopter to pair
with TX. When close, please cut the power of helicopter first, and then turn off the TX.
5. Keep away from crowd, cars, high-tension towers and pond. Then you can start your
flying.
BIND WITH TRANSMITTER
You buy the original model The pairing has been reset before factory. If you need to pair
again, please comply with the following steps.
1. Open the transmitter and make sure the throttle is in the bottom position, and the 3D1
IDLE switch is in the OFF position.
2. Take down the canopy for touching the code switch.
3. Charge the helicopter, the red lamp flashes slowly, press the code button for 1 second,
then the red lamp will go out and get ready for pairing.
4. When the red and blue lights turn solid, the pairing has been successful.
5. Ensure there are no other the transmitter of the same type at work to avoid
interference.
Tips:
This product is compatible with all FUTABA 2.4GHz S-FHSS transmitter.
Notice:
If the throttle of the transmitter has not been positioned at the lowest position
with the throttle switch and 3D mode switch turned on, the transmitter will beep
to prompt you that it fails to proceed to pair.
- 5 -
Summary of Contents for F180
Page 2: ......