11
11.1
+
12
13
12.2
13.1
13.2
13.4
13.5
13.3
12.1
MOTION
CM-35 ELECTRONIC CURTAIN MOTOR
MOTION
CM-35 ELECTRONIC CURTAIN MOTOR
It is possible to only delete end limits or to do a factory reset.
Factory reset will delete the end limits and remove the connection to any paired remote.
Press the program button on the motor to activate program mode.
Delete end limits:
To delete the end limits of the blind hold the
program
button
until the blind stops stepping for the first time, keep holding the button until the
blind stops stepping for the second time. (approximately 10 seconds)
Factory reset:
To reset the blind to factory defaults hold the button for at least 20 seconds.The blind will
stop stepping twice. After the second stop the blind will give one extra step to confirm factory reset.
Reset the blind
Hold the
program
button to manually operate
the blind.The blind will move as long as the
button is being pressed. (max. 15 sec.)
To move the blind in opposite direction, release
the
program
button and repeat step 12.1.
In case there is no remote control or pull control, the blind can
be operated with the program button on the motor.
Advanced options
The remote starts searching
for blinds (search mode).
This is indicated by the LED’s
flashing from left to right.
To activate
Single select
simultaneously
hold the
center
button and press
the
pair
button.
To search for
the next blind
press the
right
button. Search
mode will be
activated.
To find the
previous blind
press the left
button.
To exit
Single select
press the
right
button
during
search
mode.
Once a blind is found the
channel LED will flash
and the blind starts
stepping, indicating that
program mode has been
activated. The blind
can now be (un)paired
to the remote and/or
programmed.
Single select makes it possible to activate program mode on a single blind through a
remote control, without having to physically press the program button on the blind.
Manual control
Single select 5 channel remote
English
20
21