MOVE
- EDITION - V 1.0
17
User
Manual
10.14
Anti-tippers
10.14.1
Adjusting the Height of the Anti-tippers
The anti-tippers should be between 1½ and 2 ¾ inches (40
to 70 mm) off the ground. Improper spacing may result in
wheelchair hang ups over obstacles or not preventing the
wheelchair from tipping.
• Press the push-button (1) (Fig. 29) and slide anti-tippers
extensions to desired length.
• Ensure the button snaps back into place.
Fig. 29
If you are unable to adjust the anti-tippers to the proper
height, contact your Motion Composites dealer to
replace your anti-tipper for another size.
10.15.
Headrest Kit and
Headrest Support
10.15.1
Installing a headrest support
• Cut the end of the
push-handle grip with a
knife in order to be able
to see the inside of the
push handle.
• Insert a 1/4”-20 grip nut
(1) (Fig. 30) with the
grip nut insertion tool
(2) inside the handle (40
mm).
• Install fastening device
of the headrest support
by tightening it in the
1/4”-20 roll pin.
Fig. 30
10.15.2
Installing Headrest Kit
• Once the headrest support is installed, insert the adjustable
headrest into the horizontal receiver.
• Install headrest on the ball pivot and tighten the three screws
(1) (Fig. 31).
• Once the adjustment is completed, firmly tighten all parts.
Fig. 31
