Motic BA210E, Instruction Manual

Page: 23 / 28

22
8. CARE AND MAINTENANCE
8.1 Do not disassemble

Disassembly may significantly effect the performance of the instrument, and may result in electric
shock or injury and will void the terms of the warranty.

Never attempt to dismantle any parts other than described in this manual. If you notice any
malfunction, contact your nearest Motic representative.
8.2 Cleaning the microscope
8.2.1 Lenses and filters

To clean lens surfaces or filters, first remove dust using an air blower. If dust still persists, use a
soft/clean brush or gauze.

A soft gauze or lens tissue lightly moistened with the mixture of alcohol and ether
( ratio : alcohol : 3 and ether: 7) should be used to remove grease or fingerprints.

Use only a mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) to remove immersion oil
from objective lenses.

Because the mixture of alcohol and ether ( ratio : alcohol : 3 and ether: 7) is highly flammable, be
careful handling around open flame.

Do not use same area of gauze or lens tissue to wipe more than once.
8.2.2 Cleaning of painted or plastic components

Do not use organic solvents (thinners, alcohol, ether, etc.). Doing so could result in discolouration or
in the peeling of paint.

For stubborn dirt, moisten a piece of gauze with diluted detergent and wipe clean.

For plastic components, only moisten a piece of gauze with water and wipe clean.
8.3 Disinfecting the microscope

Follow the standard procedures for your laboratory.
8.4 When not in use

When not in use, cover the instrument with vinyl dust cover and store in a place low in humidity
where mould is not likely to form.

Store the objectives, eyepieces and filters in a container or desiccator with drying agent.

Proper handling of the microscope will ensure years of trouble free service.

If repair becomes necessary, please contact your Motic agency or our Technical Service direct.