Motic BA210E, Instruction Manual

Page: 13 / 28

12
3.3 Reckless stage

Remove specimen holder for fast hand scanning of slides.

Left hand operation stages is available for option. It should be used with the short stage knob for
avoiding to interfere the fine focus knob..
3.4 Specimen holder

Attach the specimen holder, using the two mounting holes.
3.5 Objectives

Lower the stage completely. Screw the objectives into the revolving nosepiece so that clockwise
rotation of the nosepiece brings the next higher magnification objective into position
.
3.6 Condenser

Raise the stage by turning the coarse focus knob.

Raise the condenser carrier by turning the condenser focus knob.

Insert the condenser into the mount with aperture scale facing forward towards the user.
Secure with the condenser clamp screw.

Turn the condenser focus knob to raise the condenser as far as it will go.
3.7 Eyepiece tube

Loosen the eyepiece clamp screw. Insert the round dovetail mount on the eyepiece tube into the
round dovetail mount on the microscope arm. Tighten the eyepiece tube clamp screw to secure the
eyepiece tube in place.
3.8 Eyepieces

Use the same magnification eyepieces for both the eyes.

To lock the eyepiece, insert each eyepiece completely into the eyepiece sleeve and tighten the
clamp screws.

Twist the eyepiece (anti-clockwise or clockwise) with 20~30 degree (Fig.1) and pull the eyepieces
gently out when removing the eyepiece. (Fig.2)