Motic 1100201000026, Instruction Manual

Page: 6 / 20

6
RED 30 SERIES
1.5 Operation
When using the stereo microscopes, please pay attention to the following safety instructions:
• If it is used for any purpose other than the specified ones, including any individual component or part,
the manufacturer will not take any responsibility.
• After-sales service or repair done by unauthorized personnel will void the warranty.
• Anyone who uses the instrument should receive instruction on the proper handling of the instrument and safety
practices for microscopy. The stereo microscope shall be placed only on a firm, flat workbench for operation.
• Since the stereo microscope is a precision instrument, improper operation will impair or spoil its performance.
• The power unit is integrated in the main unit of the stereo microscopes: the grid supply voltage is within
100-240V~50Hz.
The stereo microscopes must be connected only to the normal power socket with a groun-
ding terminal. Any extension cord without ground protection is not allowed to avoid failure
of the protection function.
If there is any electrical failure (of the fuse system, ground protection or transformer),
turn off and unplug the unit immediately. Make sure the stereo microscope is set aside so
it will not be used again and contact the Motic service department or a Motic microscope
repair agency to have it repaired.
Please be sure to turn off the power before opening the instrument to replace LED
illuminator or replace the fuse! Only use a fuse for the rated current.
The stereo microscope is not equipped with any special device to protect against corrosive, latent infective, toxic,
radioactive or other hazardous samples. Therefore, when examining any such sample you must comply with the
relevant laws and regulations, in particular the provisions related to accident prevention.
1.6 Quality Warranty
The
RED30 Series stereo microscopes and the attached accessories are only allowed to be used for stereo micros-
cope examination as described in this manual. The manufacturer takes no responsibility for any other use.
• The manufacturer guarantees that the product is free from any defect in material or workmanship on the date of delivery.
• If any defect is found, notify the manufacturer immediately.
• Upon receipt of the Notification of Defect as described above, the manufacture is responsible to solve the problem
either by repairing the defective instrument or replacing it with a new instrument of the same model.
• The manufacturer provides no warranty for any failure or defect due to normal wear and tear or improper use of
the product.
• The manufacturer takes no responsibility for any damage caused by operation error, negligence or unauthorized
dismantling of the instrument, or the use of spare parts from other manufacturers.