Motic 1100201000026, Instruction Manual

Page: 10 / 20

10
RED 30 SERIES
3.1 First time use
Before installing and using the stereo microscopes, make sure to read carefully the Safety Instructions (See Chapter 1).
When unpacking and handling, please do not touch the optical surfaces and do not leave any component or accessory
in the packing box.
• After unpacking, place the stereo microscope on a flat workbench and remove the wrapping paper and packing
materials of the eyepieces and other optical components (do not touch the lens surface). Make sure the lock
screws of the eyepieces are adjusted correctly. The eyepieces should turn easily, but should not be able to be
pulled out.
• Connect the charger to the power supply. Before plugging in, keep in mind that the working voltage
of the stereo microscope must be the same as the supply voltage (100~240VAC 50/60Hz). (Figure 1)
• Turn on the power switch at the back of the base. (Figure 2)
Note: Make sure that the brightness control is in the minimum position before turning on or off the power switch.
3. FIRST TIME USE & OPERATION