Motas Motas-6, User Manual

Page: 24 / 62

[TIP] Modulate the MASTER PITCH with the
dedicated LFO and use the modulation option LFO-
MOD-EG to create a vibrato effect that is delayed
and builds in amplitude as a key is pressed, accord-
ing to the EG setting for that parameter page.
LFO single-shot
OFF the LFO runs continuously.
S ON the LFO will do one cycle of oscillation
(however this is only active when the LFO is
also set a sync. mode, see below).
LFO sync/reset options
OFF the LFO is not reset on note-on
or gate signals.
EG-TRIG FIRST NOTE the LFO resets on the
first note-on or gate signal.
LFO-RESET ALL NOTES the LFO resets on all
note-on or gate signals.
LFO pitch track options
F/S OFF LFO frequency does not track pitch.
N NOTE LFO frequency will track the last played note
including pitch bend and global tuning and offset.
P PITCH LFO frequency will track as per NOTE
and also track the
[BUTTON-MASTER PITCH]
page.
LFO frequency modulation
The active global LFO and EG for this parameter page can
modulate the dedicated LFO frequency. Set the amounts
here under FREQ MOD LFOX and
FREQ MOD EG. The amount is shown in % or in cents/semi-
tones when the LFO is set to track note or pitch.
[TIP] Try setting the dedicated LFO to mod-
ulate the phase modulation amount (oscillators 2
or 3) with LFO frequency modulation from a global
LFO and/or the EG for some really complex sound
effects!
Press the
[BUTTON-LEFT]
or
[BUTTON-RIGHT]
button again to
return to the main parameter page display.
9.5 Envelope Generators (EG)
Each parameter page can be assigned either a dedicated
local EG (labelled on the screen as EG) or one of four global
EGs (labelled on the screen as EG1, EG2, EG3 and EG4).
The EG creates a signal that varies over time. It consists
of 5 phases. The first phase ’delay’ is started by a MIDI
note-on or gate/trigger activation. The final release phase
starts by a MIDI note-off or gate/trigger de-activation (if
the EG is not in ’trigger’ mode).
[BUTTON-EG DELAY]
D delay – sets the delay in time before the
attack phase starts (0 to 2.43 seconds).
[BUTTON-EG ATTACK]
A attack – sets the time for the envelope
to rise after the delay phase (1 ms to
34.6 seconds).
[BUTTON-EG DECAY]
D decay – sets the time for the envelope
to fall after reaching the maximum
level in the attack phase (1 ms to
34.6 seconds).
[BUTTON-EG SUSTAIN]
S sustain – sets the level to which the
envelope falls at the end of the
decay phase.
[BUTTON-EG RELEASE]
R release – sets the time that the
envelope falls from the sustain level
(1 ms to 34.6 seconds).
Press
[BUTTON-UP]
and
[BUTTON-DOWN]
simultaneously to re-
set the values to defaults.
Amount
Attack Decay
Sustain
Release
Time
Key released Key pressed
100%
Delay
User Guide v1.31 [FOR SCREENREADERS]
page 19