Shutting down the motor
GE 4500 HSX
GE 7000-7500 HSX
M
27
REV.0-06/04
04/06/04 35455-GB
SHUT-DOWN FROM FRONT PANEL
1
. Position the LOCAL START /REMOTE
START (I6) selector on LOCAL START;
2
.
to shut down the motor in an
emergency situation, turn the key
(Q1) to the OFF position;
3
. to stop the motor under normal conditions,
proceed as follows:
3a. interrupt the power source, switching
off all tools connected. If a tool does
not feature a power switch, lower the
G.F.I. switch lever (D);
3b. allow the motor to run without any load
for a few minutes;
3c. turn the key (Q1) to the OFF position.
SHUT-DOWN FROM REMOTE
OFF
ON
START
The start-up selector (I6) LOCAL START / RE-
MOTE START enables the start-up and stop
controls for the selected position.
From the REMOTE START position, the start-
up key on the front panel is completely disa-
bled; to stop the generator, use the controls
on the TCM or EAS panel.
WARNING
!
+
NB.: as a safety measure the start-up key
must be entrusted to qualified personnel.
The unit can also be shut down by means of the
TCM remote control or EAS panel.
- Check that the EAS (B3) connector is con-
nected to the cable from the TCM or EAS
panel.
- Verify or position the LOCAL START / RE-
MOT START (I6) selector on REMOTE
START.
SHUT-DOWN with TCM
Follow the operating procedures for shut-down
under normal or emergency conditions, as de-
scribed in the paragraph SHUT-DOWN FROM
FRONT PANEL, using the key (Q1) on the TCM .
SHUT-DOWN with EAS
Shut-down is controlled automatically.
See operating manual for the EAS panel.
At the end of each use of the generator, close
the gasoline tap (87).
In case of an extended period of inactivity of
the generator, switch off the motor by closing
the gasoline tap (87); this precautionary mea-
sure serves to avoid probable deposits in the
carburettor.
