USE
WELDING DIGITAL CONTROL
M
33.
1
REV.1-01/08
I
GB
F
GETTING STARTED
1)
After having prepared the machine (charged the
battery, put in oil and fuel) the machine is ready
for operation.
Before starting the engine please note the following:
- The welder should only be operated by qualified
personnel with experience in working with engine
driven welders.
- Check the oil level daily. Fuel should be put in
before starting the engine.
- Before using the welder or the auxiliary power let
the engine warm up and before stopping the engine
let it run without load to cool down.
Refer to the following instructions regarding the
function of the various controls on the front panel.
2)
Start the engine of the welder
OFF
ON
START
3)
Turn the welding current/voltage
adjusting knob to the minimum
setting.
SETTING THE WELDING PROCESS
11/10/04
M33_WDC_GB
CV
CC
STAND-BY
CONTACT
STARTING
REMOTE
CONTROL
70
20
25
40
100
WELDING DIGITAL CONTROL
130
160
190
220
250
280
310
340
370
400A
36V
16
10
30
ON
POLARITY
CURRENT CC
MAX
50%
INVERTER
RANGE
TIG
ARC FORCE
CELLULOSE 1
CELLULOSE 2
CC-STICK
CV-WIRE
There is a manual switch for selecting the various
welding processes on the welding control panel.
There are 5 processes to choose from:
1 for TIG welding
3 for STICK welding (electrode)
1 for MIG/MAG welding (continuous wire).
The switch can also be set to “stand-by” (first po-
sition). In this position there is no current at the
welding connections; led “ON” off.
The process can be selected either before or after
starting the motor powered welder.
After selecting the mode, the “ON” LED lights up.
If the wirefeeder connector is connected on remote
control connector the “ON” LED lights only when the
button torch is pressed.
