Mosa DSP 2x400 PS-PL, Use And Maintenance Manual

Page: 30 / 46

ACCESSORY USE
REMOTE CONTROL
RC2 (PL Version)
RC2/90° (PL Version)
M
38.10
REV.2-09/10
The remote control RC, which regulates the welding
current in the CC (STICK welding) mode and the
welding voltage in the CV (MIG/MAG welding), is
connected to the front panel by means of a multipole
connector.
When the remote control is connected to the remote
control connector (8), it is functional and automati-
cally excludes the front panel regulation. The remote
control can also be connected to the connector on
the wire feeder front panel but in this case it is ne-
cessary to switch the wire feeder commutator so it
can operate.
Adjust the welding current control knob to the cor-
rect current for the diameter and type of electrode
being welded.
PUSH AND
SCREW TIGHT
09/04/02 M38GB
ATTENTION
When the RC is not used, it is necessary to disconnect the
multipole connector
!
PUSH AND
SCREW TIGHT