EQUIPMENT PREPARATION
18
Installing the WLAN Antenna
The ELI 280 with optional WLAN module ships with the antenna in the accessory box. To install the antenna,
perform the following:
1.
Locate and remove the antenna from the accessory box.
2.
Locate the antenna connector on the back of the ELI 280.
3.
Mount the antenna on the connector by rotating the antenna clockwise. The antenna must be finger tight to its
connector.
4.
Locate the built-in hinge and fold the antenna (it will now be at a 90° angle); continue to rotate the antenna
clockwise until it is placed vertically. This will guarantee the best signal for the WLAN module.
NOTE:
To configure for WLAN use, see Connectivity and ECG Transmission.
Using the WAM or AM12 Acquisition Module
ECG acquisition and rhythm strip printing can also be performed at the WAM or the AM12 acquisition modules.
To use the WAM, refer to the WAM user manual. To use the AM12, refer to the AM12 short-form instruction card.
The ELI 280 must be configured at the factory for use with the WAM. If the ELI 280 is configured for use with the
WAM, the two devices must be paired to function properly. Please see the WAM user manual for pairing
instructions.
NOTE
: WAM must be paired to electrocardiograph before operation. Refer to the WAM operators manual
for assistance in pairing the WAM.
NOTE:
If no patient connection is detected after 15 minutes, the WAM will turn off.
Summary of Contents for ELI 280
Page 5: ......
Page 6: ......
Page 26: ...INTRODUCTION 20 System Illustration Figure 1 1 Side View Figure 1 2 Writer Handle ...
Page 32: ......