4
DK ENG
Installation of woodburning stoves must be safe and legal.
If your Morsø stove is not installed correctly, it may cause a house fire. To reduce the risk
of fire, the installation instructions must be followed carefully. Contact the local building
officials about restrictions and installation inspection in your area.
Before you start installing your stove, make sure that:
- The stove and chimney connection are placed far enough from combustible materials to
meet all clearance requirements.
- The floor protection must be adequate and must be made correctly according to the re-
quirements.
All neccessary approvals are needed from the local building officials.
The data plate, which is located on the back of the stove, provides information regarding safety
testing information, name of certified testing laboratory, and installation requirements.
Installation requirements vary in different districts, and the local building officials have the final
authorization to approve your installation. You should discuss the installation with them before
beginning. Please ask your dealer for further information.
Do not connect to any air distribution duct or system.
Important: If the installation instructions are not followed carefully, it may cause dan-
gerous situations like chimney - and house fires. Follow the instructions carefully and
do not deviate from them as it may cause injuries to people or property.
1.1 Checking loose parts in the stove
After unpacking, check that the center grate (in the centre of the fire bed) and the fire bricks
are firmly in position and have not shifted in transit. Check also that the air control works freely.
The stove is heavy and therefore it is strongly recommended that when lifting, it is under-
taken by two people.
Fitting instructions for Legs
Morsø 3112: After removing the outer packaging, flatten it and lay onto the floor close to the
stove; this can then act as protective work surface during the assembly process.
Next, remove the legs and bolts from inside the stove. Gently lay the stove onto its back and
unscrew it from the wooden pallet. Using the bolts supplied, now screw the legs into position
on the underside of the base. The stove should now be lifted and moved into the upright posi-
tion, avoiding excess load on the back legs.
Morsø 3142: After removing the outer packaging, the stove should now be lifted and moved
into the position.
1.0 Installation of your Morsø stove
Summary of Contents for 3112
Page 7: ...7 ...
Page 19: ...19 3 5 Parts diagram for model Morsø 3112 3142 ...
Page 22: ...22 G ...
