Installing the Insert into the Enclosure
Prepare the Insert
Refer to the Morsø Installation and Operating Instructions for either Model 5660 NA Standard or
5669 NA with New Blower for instructions on how to prepare the insert for installation.
Follow the Blower Installation instructions on page 14 if you are installing the Insert with the optional
blower. Plug the blower power cord into the electrical outlet in the side of the enclosure. Route the
power cord between the insert stand and the enclosure side.
In order to connect the chimney to the insert it is necessary to remove the baffle and firebox liners.
It is not necessary to completely disassemble the insert. Do not remove the cast iron flue collar.
The instructions in the Morsø Insert manual will show you how to do this starting on page 6.
Install the Insert into the Fireplace Insert Enclosure
1. Using a helper or stove lifter, place the insert on the platform inside the enclosure. Push the in-
sert back into the enclosure opening until the insert flange contacts the facing material. Check to
be sure the insert is centered in the enclosure opening.
2. Adjust the leveling screws until the face plate is level and plumb or aligned with any joints in the
facing material.
3. Reach up through the flue opening and pull down on the stainless steel 45° slip connector elbow
using the handle provided in the elbow. Make sure the connector elbow is full engaged in the
insert flue flange. See FIG. 11.
4. Bend the two tabs over to secure the connector elbow. See FIG. 12.
5. Replace the baffle using the reverse order for removal.
6. Replace the stones (firebrick).
7. Replace the door
Chimney Base/
Anchor Plate
Stainless Steel
Flex Connector
Stainless Steel
45° Slip Elbow
Flue Flange
FIG.11 Cutaway View Showing Flue Connection
11
FIG.12 Bending Flue Tabs
V1.US