morse KP 286, User Manual

Page: 29 / 70

SOFTWARE SETUP
Ш-2.4 Example to Preformat a 20MB (Type 2)
Hard Disk.
III-2.4.1
Move highlight bar and press < ENTER> to select ‘Hard Disk For­
mat ’ (this means you will preformat the hard disk). Then type ‘C’ to select 'Disk
Drive C:’.
Press the “t ” or “I ” to move highlight bar for 'Disk Driver type’
and hit < ENTER> to confirm.
Refer to the figures below:
Hard Dist Format
Disk Drive [C/D] ?C
Disk Drive type ?2
Interleave [1-6]
?
Mark Bad Tracks [Y/N]
?
Start cylinder number
?
End cylinder number
?
Start head number
?
End head number
?
Proceed [Y/N]
?
Type Cyl. Heads W-pcomp L-zone Capacity
1 306 4 128 305 10 MB
2 615 4 300 615 21
3 615 6 300 615 31
4 940 8 512 940 63
5 940 5 512 940 47
6 615 4 FFFF 615 21
7 462 8 256 511 31
8 733 5 FFFF 733 31
9 900 15
FFFF
901
112
10 820 3 FFFF 820 21
11 855
5
FFFF 855 36
12 855 7 FFFF 855 50
13 306 8 128 319 21
14 733 7 FFFF 733 43
15 000 0 0000 000 00
16 612 4 0000 663 21
Move Bar- Select- f 4 <RET> Quit-
<ESC>
Ш-2.4.2
The default interleave is 3:1, some higher performance HDD con­
trollers such as the ‘KP-2000’ have a higher data transfer rate and support in­
terleave 2:1. Type “ 2” and press < ENTER> to change the interleave to 2:1.
26